I. Refurbishment Details: Precise Control to Reshape QualityAfter a professional assessment of the initial condition of the vehicle, a comprehensive refurbishment was initiated.

The used Toyota Coaster, refurbished for the Ghanaian client, has been fully completed and is about to embark on a new journey. This is a customized school bus for an elite school in Africa. The client had clear requirements for the vehicle's seating layout and interior design.

This is a used bus shipped to Burkina Faso from the port of Tianjin, China. It has undergone secondary maintenance in a professional factory and has also been repainted in custom colors. The bus is left-hand drive, 50 seats, with sliding windows.

Here are two second-hand buses we refurbished for a Zimbabwean client. We carried out a full refurbishment of these two vehicles in a professional factory. First, the engines were disassembled to replace six important components such as new pistons and piston rings. Then, the vehicle chassis were fully refurbished, and each axle was opened to replace new brake pads and bolts.

3.5 Maintenance1) After every running of 30,000km, remove and clean the leaf spring, apply graphite grease on between the spring leaves, add or replace antifriction pieces on the ends of the leaves of the variable-section leaf spring, and then reassemble them.2) After the vehicle has a total running

3.4 Assembling1)Before assembling, spread a film of grease on the spring lining and the shackle2) Assemble the shackle onto the shackle bracket, put side gaskets on both sides of the shackle, insert the shackle pin in, fix the pin bolt, with tightening torque of 30-50N·m.3) Assemble the padding plat

3.3 Inspection1) Use special measuring instruments or tools for part inspection, Determine whether parts can be used any longer according to the specified Maintenance Table, Repair and replace damaged parts as required, In case of any worn part among mating parts, which makes the clearance exceed th

3.2 Cleaning1)Cleaning NotesCleaning is necessary due to accumulation of oil and dirt on the part. Use suitable cleaning methods such as steam purging light oil rinsing, neutral cleanser washing, trichloroethylene steam cleaning and shakable washing solution (magus Solution) used in washing machine.

3、Maintenance procedures3.1 Disassembling1)Disassemble shock absorber lower end.2)Disassemble shock absorber upper end and shock absorber itself.3) Loosen U-bolt and nut, then remove U-bolt, cover board, buffe block, and padding plate with absorber lower-end lower pinembly.4) Jack up front axle, sup

1. Pressure plate 2.Bushing 3.Suspender4. Stabilizer rod 5. Upper bracket ofsuspender6. Antifrictrion piece 7.Leaf spring pin 8. Flexible shackle 9. Fixed shackle 10.Shackle pin 11. Spring cover12.U-bolt 13. Fixed shackle 14.Clasp15.1st piece of leaf spring 16.2nd piece of leaf spring 17.Upper brack