5 、Troubleshooting

2) Install the grease nipple, which should be installed on a position with a 45° to the spider neck.3) Install the flange fork.Take off cups on both ends of the spider, put them in the holes in the flange fork, install two cups and retainers (for cover plate type, install the cover plate, lock wash

The refurbishment of the bus for the Zimbabwean client has been fully completed and has been successfully delivered to the Tianjin Port. It is about to embark on a new journey.The client has clear requirements for the seating layout and interior design of the bus. We have changed the number of seats

(3)Spline clearance inspectionCheck the spline fit clearance between the splined shaft and the spline fork.Maintenance standard: 0.11-0.2mm; repair limit: 0.5mm.(4) Clearance between universal joint spider neck and the journal bearingInstall the needle bearing assembly on the spider, check the clear

3) Cleaning of rubber parts Rubber parts are not allowed to be washed by mineral washing oil. Instead, they should be washed in alcohot; or alternatively. the dirts on the surface should be wiped off via a piece of clean cloth.4) Purge of oil pipeline Use steel wire to get through the oil circuit

9)Remove the dust sealing ring and the grease nipple from the spider.10) Clamp the spline fork in the vice, remove the boot, felt and grease nipple.4.2 Cleaning1) Cleaning Notes Cleaning is necessary given the accumulation of oil and dirt on the parts. Ways of cleaning suitable for the cleaning inc

On the March Purchasing Festival, Yunnnuo Automobile will offer customers the best price.The promotion activity in March starts on March 1st and ends on March 31st.If we receive the deposit in March, we have various gifts for customers.Yunnuo Automobile China have Toyota Coaster, Yutong buses, Sinot

Note: If the flange fork is provided with cover plates on both sides, beat out the lock washer of the bolt, unscrew the bolt and take off the clamping plate.(3)Remove the cup on one end in the axial direction of the spider with a press (or hammer) (take care not to disorder or loseneedle rollers in

This week, the fourth and fifth Toyota Coasters renovated for a Nigerian customer have been fully completed and successfully transported to the port. They are about to set sail for the African continent. This achievement not only marks the entry of the cooperation between the two parties into a new

6) Remove the joint between the transmission and the transmission shaft and remove the transmission shaft assembly from the vehicle.7) Before disassembling the transmission shaft, make aligning marks as shown in the figure.Aligning mark8) Remove the flange fork.(1) Remove the two retainers on both s